OVN-Kubernetes CNI plugin support on Openshift
Prior to AKO version 1.10.1, only OpenShift SDN was supported as the Container Network Interface (CNI) plugin on OpenShift. Starting with AKO 1.10.1, the OVN-Kubernetes Container Network Interface (CNI) plugin is supported in OpenShift.
Configuring AKO to use OVN-Kubernetes CNI Plugin on OpenShift
In order to support OVN-Kubernetes as the CNI plugin with AKO, the AKOSettings.cniPlugin value in the AKO Helm chart values.yaml should be set to
For more information, see Configuring AKO.
AKO needs to read the pod CIDR subnets configured for Kubernetes or Openshift nodes to create static routes in the Avi controller for the pool backend servers (pods) to be reachable from the Service Engine. The OVN-Kubernetes CNI configures the Pod CIDR subnet on each node as part of the
k8s.ovn.org/node-subnets annotation. AKO reads the default pod CIDR subnet value from this annotation for each node and configures the required static routes on the Avi controller. A sample annotation value is shown below.
NOTE: AKO only supports a single pod CIDR subnet per node configured as default in the
- Pools are down when running AKO with service type as
For OVN-Kubernetes CNI, there are some Openshift setup installations where, by default, the routing gateway (OVS) performs Source NAT for traffic from PODs leaving the nodes. This Source NAT results in the pool servers, i.e., pods, being marked down in the Controller as it leads to failure in the health monitoring performed by the NSX Advanced Load Balancer Controller. This issue is seen only when AKO runs with the service type configured as ClusterIP (ClusterIP mode). No such issue is seen in the NodePort mode, and pools come up normally. To learn more about
serviceType configuration, see Configuring AKO.
To use ClusterIP mode, the Source NAT has to be disabled. However, disabling SNAT will break the ability of pods to route externally with the Node’s IP Address, there by leading to failure in NodePort mode. NodePort mode should be leveraged if disabling SNAT is not desired. The changes below will disable the SNAT functionality for the namespaces that require Ingress/Route support.
- Create a ConfigMap to set disable-snat-multiple-gws for cluster network.operator. Create a file named cm_gateway-mode-config.yaml with the following:
apiVersion: v1 kind: ConfigMap metadata: name: gateway-mode-config namespace: openshift-network-operator data: disable-snat-multiple-gws: "true" mode: "shared" immutable: true
Create ConfigMap with
oc apply -f cm_gateway-mode-config.yaml
k8s.ovn.org/routing-external-gwsannotation to namespaces that require Ingress/Route support.
- Edit any namespace with
oc edit namespace <name-of-namespace>and add the
k8s.ovn.org/routing-external-gwsannotation as shown below:
- Edit any namespace with